[2023-12-19] The latest version of PowerUSER is required to connect to new inverters. For more information see the below link:https://danfosseditron.zendesk.com/hc/en-gb/articles/5045659438877-EC-C1200-hardware-modifications-and-required-actions-due-to-it- |
The PowerUSER program offers pre-made templates for the signal scope feature. These templates allow the user to quickly configure a basic signal scope setup for common troubleshooting and commissioning tasks.
Note: If the templates are not available, please update your PowerUSER program to the latest version, downloadable via the Danfoss Editron website.
To load a signal scope template, start by clicking the "configure" button on the signal scope:
Next, select the correct template according to which application type is in use:
After the template signals have been added to the list, click "next". More signals can be added later as needed from the signals tab.
You can choose to limit the sample rate or maximum log file buffer size, leave them "Off" unless you have problems running the signal scope. Then click on "OK":
You have successfully set up the logging template, you can then start the scope recording by clicking on "RUN":
If you have run into some issues running your devices and are considering asking for assistance from the Danfoss Editron Service department, these logs along with a parameter backup are a very good start for troubleshooting and diagnosing issues.
For more information regarding the signal scope usage, see the PowerUSER quick guide by pressing the "?" icon in the top right corner of the PowerUSER program.